|
|
12-11-09, 12:42 AM
|
#20 |
|
Registered User
Join Date: Nov 2001
Posts: 1,271
|
if you really want it flat, then as people have said you'll need to get it ground. BUT, you 'll also need to stress relieve it first. The bow is mostly likely caused by internal stresses when it was machined. It will continue to move again if you machine it again unless it's first stress relieved.
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Number Plate Protectors have disrepected my personalised plates! | BOOTHY | General Discussions | 63 | 06-11-08 10:13 PM |
| Tilton OT-II Triple plate clutch... 7.25" (185mm). | Wobbz | Cars - General Car Parts For Sale or Wanted | 3 | 09-10-08 09:19 AM |
| Massive shed cleanout | GlennoOfDem | Cars - General Car Parts For Sale or Wanted | 17 | 11-02-07 01:00 PM |
| sandwich plate on a sandwich plate? | jbonevia | General | 3 | 26-04-06 10:59 PM |
Threaded Mode